Specify a IPSec tunnel down detection time. The minimum is 20 Seconds. If Controller is selected, all gateways share the same tunnel down detection time.
Aviatrix gateways samples the tunnel status every 10 seconds.
In normal state, Aviatrix gateways send keep alive messages to the Controller. Keep Alive Speed determines when Controller determines if a gateway is down.
See Gateway State for more information.
Go to Advanced Config -> BGP
BGP Transit GW List¶
If you setup a Transit Network, Transit GWs will be listed under Settings -> Advanced Config -> BGP.
Select one Transit GW to view details.
- Advertised Networks represents the list of Spoke GW CIDR list.
- Learned routes represents the list of on-prem network propagated by VGW.
- Local AS Num is the Transit GW AS number you specified at the time of Step 3 when connecting to VGW.
The BGP dampening feature can be used to suppress flapping routes. It is disabled by default. Currently you cannot configure dampening parameters.
Aviatrix BGP is implemented by using Quagga.
To troubleshoot BGP problems, go to
Advanced Config > BGP > Diagnostics
You can either type in Quagga commands or use the to select one of the pre-defined commands.
Overlapping Alert Email¶
Aviatrix, by default, will alert you if you add a spoke that overlaps with your on-premise network (or, if you start advertising a network from on-premise that overlaps with a spoke). However, there are some cases where you expect overlaps and the alert emails are not helpful. For these cases, you can disable the overlap checking. To do this go to
Advanced Config > BGP Alert Email > BGP Overlapping Alert Email
Toggle the switch to Disabled to disable overlap checking.